hacking car keys / hacking garage keys with Raspberry PI + RTL SDR dongle + RPITX in 5 minutes !

[ENABLE CAPTIONS!] In the video I am showing how to clone any radio signal of car keys / garage keys with cheap Raspberry PI and RTL SDR dongle with RPITX application. This is the same method as used for relay attack / car rolljam attack to unlock a car. The point is that it is not required anymore to have expensive YardStick ONE or HackRF equipment to perform such activities as RF signal replication ... I am using second hand Raspberry PI 3B that I bought for only 30$ with software defined radio application and dongle. This video has only educational purposes so you could be aware of current hacking techniques. I am not trying here to teach you how to hack into a car. I am just showing how easy it is nowadays to perform radio targetted attacks so you could have some basic knowledge how to protect yourself and your assets... Remember to protect your car by not using RF communication where unnecessary (open door rather by turning the key instead of using remote openning) f.ex. in shopping malls and other places where potential hacker may wait for you. The RPITX project is available here : https://github.com/F5OEO/rpitx What do you need : 1. Raspberry PI device ( I have used Raspberry 3B ) 2. Short antenna applicable for frequency you want to replay ( 433MHz : 17.3cm / 6.8' inch , 315MHz : 23.81 cm / 9.37 inch , 868MHz : 10.6cm ) - antenna has to be connected to GPIO4 pin of Raspberry Pi ( look here for info : https://www.raspberrypi.org/documenta... ) 3. RTL SDR dongle for 15$ - I am using shielded RTLSDR v2. Ensure you have quality built device 4. An application on Raspberry Pi : RPITX from Evariste Courjaud (thanks Evariste !!!) a) First Step - you need to have your Raspberry Pi with Raspbian SD card - prepared to work with RTL-SDR dongle - look here for some tutorials : https://hamprojects.wordpress.com/202... , here on github : https://gist.github.com/floehopper/99... or here https://drwxr.org/2017/04/setting-up-... b) Second Step - Install the RPITX app on Raspberry Pi : sudo apt-get update sudo apt-get install git git clone https://github.com/F5OEO/rpitx cd rpitx ./install.sh RUN rtlmenu & Enjoy : sudo ./rtlmenu.sh installation tutorial from the scratch https://youtu.be/hoSlkv-9a2I If you liked it is please leave a LIKE and SUBCRIBE for more amazing videos ! Thanks !